65 Mop Basin
  • 1-Piece, Molded Construction — made with white DURASTONE®
  • 24"x36"x10" with Elevated Drain Shelf
  • Integrally Molded Center Drain with Seal
  • Connects to 3" Iron Steel Pipe
  • Easy to Install

Code Accepted
DURASTONE® Mop Basins meet or exceed performance requirements:
  • IAPMO® Listed — file numbers: Shower Floor — #1453; Drain — #1251 and #1635
  • American National Standards Institute (ANSI) — Specification 124.6
  • Warnock Hersey Listed — CSA test standards: Mop Basin — #B45.0 and #B45.5

Accessories — order separately...
Part No.Description
63.600A Service Sink Faucet
65.700 Hose and Hose Holder
65.600 Mop Hanger
63.401 Bumper Guard — 20-3/4" length
65.403 Bumper Guard — 32-3/4" length
67.2436 DURAGUARD™ Wall Guards
65.308Drain Seal
65.311Drain Seal


  SPECIFICATIONS

Model No. Size UPC
65M 24"x36"x10" 6 71031 00194 8
Sectional ViewPlan View

General: Furnish and install as shown on plans, Mop Service Basin model 65M, as manufactured by E.L. Mustee & Sons, Inc. Unit to be one-piece, molded fiberglass made with matched metal molds using extreme heat and pressure. Height shall be 10" with not less than 1" wide shoulder. Size 24"x36" with integrally molded, self-draining shelf. Drain shall be integrally molded, complete with drain seal for installation of 3" ABS, PVC (Sch. #80) and iron pipe. Removable stainless steel strainer. Performance tested to meet or exceed ANSI Specifications Z 124.1.2, Z 124.6. Weight 62 lbs., cubic feet 7.0. Install in compliance with local codes.

Specification Sheet
Printable PDF Version
Instruction Sheet
Printable PDF Version

top


Preferred by the "Pros"

Home• About Us• What's New• Installation• Codes• Warranty• Where to Buy• Site Map
Laundry Tubs and Sinks• Bathtub Walls• Shower Floors• Shower Walls• Shower Stalls• Grab Bars and Seats
Easy Access Showers• Enclosures• Mop Service Basins• Washer and Water Heater Pans

Copyright 2006 E. L. MUSTEE & SONS, Inc. All Rights Reserved