HOME ABOUT US WHAT'S NEW INSTALLATION CODES WARRANTY WHERE TO BUY SITE MAP
 Laundry Tubs
 and Sinks

 Bathtub Walls

 Shower Floors

 Shower Walls

 Shower Stalls

 Easy Access
 Showers

 Enclosures

 Mop Service
 Basins

 Washer and
 Water Heater
 Pans

 Grab Bars
 and Seats
350 DURAWALL
       350 DURAWALL®
  • Fits Standard 5 FT. (or less) Bathtub
  • 3-Piece Molded Panels, Seamless Corners, Large Shelf
  • Available in White and Bone
  • Smooth Semi-Gloss Finish
  • Scuff Resistant, Uniform Color
  • Mildew Resistant, Easy to Clean
  • Can Be Cut Out For Window
  • Double-Sided Tape
  • Includes Adhesive and Caulk

Code Accepted
Fiberglass DURAWALL® Bathtub walls meet or exceed performance requirements:
  • American Society of Testing & Materials (ASTM)-D-635, E-165-75, E-84
  • American National Standards Institute (ANSI)-Specification Z124.1
  • Inhalation Toxicity Test - to evaluate inhalation health hazards with combustible products

For a finishing touch, look at the 300.600 DURATRIM™ window trim kit

Design Features...
Comply with ADA Specifications - design provides for proper placement of grab bars, per following:
  • The Americans with Disabilities Act - 1990(ADA) Section 4.20.4 Grab Bars
  • American National Standards Institute (ANSI) - Specification A.117.1

Grab bars must be anchored to structural support behind DURAWALLS®.
Grab bars not included.
Figure 34(a)-ADA Section 4.20.4 Grab Bars 350 DURAWALL


  SPECIFICATIONS

Model No.
Color
UPC
350WHT
White
6 71031 00266 2
350BN
Bone
6 71031 00267 9
350BT
Biscuit
6 71031 00379 9
350 DURAWALL
General: Furnish and install as shown on plans DURAWALL® Bathtub Walls, model 350, as manufactured by E.L. Mustee & Sons, Inc. The wall system shall be three-piece construction with molded-in shelf and double face tape applied to edges of underside for a better seal. Panels shall include 20% fiberglass reinforced composite material and be manufactured with matched metal molds using extreme heat and pressure with a uniform thickness of 70 mils. Shall be semi-gloss, scuff-resistant surface. Unit shall meet or exceed applicable tests, per ANSI Specification Z 124.1. Color ____ (White, Bone or Biscuit). Shall include adhesive, caulk and instructions. Weight 62 lbs., cubic feet 12.0. Install in compliance with local codes.

Carton Contains: Center panel, two corner/end panels, adhesive, caulk and instructions. Carton is 60"x55"x7".


Specification Sheet
Printable PDF Version
Instruction Sheet
Printable PDF Version

top


Preferred by the "Pros"

Home• About Us• What's New• Installation• Codes• Warranty• Where to Buy• Site Map
Laundry Tubs and Sinks• Bathtub Walls• Shower Floors• Shower Walls• Shower Stalls• Grab Bars and Seats
Easy Access Showers• Enclosures• Mop Service Basins• Washer and Water Heater Pans

Copyright 2006 E. L. MUSTEE & SONS, Inc. All Rights Reserved